BRADLEY SMOKER | "Taste the Great Outdoors"

Smoking Techniques => Hot Smoking and Barbecuing => Topic started by: laserdoc on July 03, 2011, 02:52:11 PM

Title: Internal temp for a shoulder
Post by: laserdoc on July 03, 2011, 02:52:11 PM
I rubbed down my 8 pound shoulder last night and placed it on the smoker at 8 this morning with a pan of raspberry wheat beer underneath to catch the drippings. At 5:45 the internal temp of the meat is 145 .Have been pretty steady inside the box at around 200 all day. What should my internal temp be when I need to pull it off?
Plan to chop it up tonight and pour the drip pan into it and keep it in the crock pot for tomorrow BBQ contest
Title: Re: Internal temp for a shoulder
Post by: Ka Honu on July 03, 2011, 03:06:01 PM
Pull it at 195-200o, then FTC with some of the juice for a couple of hours before pulling.  I'd turn the heat up a bit.  Your box temp should have been closer to 225o; at 200o it may never get done.  If it gets too late, it might even be time to put it in the house oven and turn the temp up a bit (300o).
Title: Re: Internal temp for a shoulder
Post by: hal4uk on July 03, 2011, 03:08:52 PM
Ditto.
Awrighten.
Title: Re: Internal temp for a shoulder
Post by: laserdoc on July 03, 2011, 04:04:43 PM
ok slid the slider all the way over. In another 2 hours I will see where it is reading.
What is FTC ??
Title: Re: Internal temp for a shoulder
Post by: laserdoc on July 03, 2011, 06:55:18 PM
Ok I pulled it when it was 170.
Chopped it up and added a bit more rub to it. poured the beer drippings in to it, All is good but I feel it is a bit to dry. Will add some apple juice to it in the morning. Probably should had pulled it at around 155. Not sure what everyone is talking about to pull it when the temp reaches 195 to 200 ????? If I had waited until it was that high I feel it would have been way to dry!!!
Title: Re: Internal temp for a shoulder
Post by: GusRobin on July 03, 2011, 08:24:13 PM
a butt/shoulder will get tender and juicy as the collegen in the meat breaks down. This happens at around 160-170s range depending upon the pig (some are stubborn). Take a butt out at 170 and taste a piece then put it back in until it gets to 195-200, FTC for a couple of hours and you will notice a big difference in tenderness and juiciness. (FTC is: Foil the meat with some juice, wrap in a towel, and put in a cooler (no ice) for a couple of hours. If you don't have a good cooler you can Foil it and put it in a microwave (don"t turn it on)
Title: Re: Internal temp for a shoulder
Post by: laserdoc on July 04, 2011, 03:57:19 AM
ok  will try that the next time!!
Title: Re: Internal temp for a shoulder
Post by: NePaSmoKer on July 04, 2011, 06:01:32 AM
180 sliced and chopped

185 slice, pull & chopped

195-205 pulled and shredded.