Recently I replaced the magnetic door seal on my BOSS 4 rack . Anyone else have experience doing this ?
Sent from my SM-G930V using Tapatalk
I have replaced a whole door, but in the process had problems with the door seal.
What do you need to know, or what's the problem?
Well, I took the old seal off then when the new one arrived I removed the piece of sheet metal to put the seal on it while it was on the bench. In the process of taking this off I removed the thermometer and before I pulled the sheet metal down a piece of galvanized strap 1 1/4 wide by 13 1/4 long with 3 screw holes (2of which)had a washer spot welded to the hole fell out. Can't figure where it belongs. There is a piece of the same material top and bottom but they are angle shaped and i see where they go as they didn't fall out. There is an indentation although small just above the temp probe that looks like this may have been there but none of the holes line up for any placement there. I just put the door back together and left it out . Not sure if it will have any effect on the door . Just wondering about this.
I know as a kid when i took things apart there was always an extra piece left over when it was put back together. This is normal right 🤣
Sent from my SM-G930V using Tapatalk
Sorry!! I can't help with this one. Hopefully someone will come along and know the answer. From the description it sounds like a reinforcement brace to make the door a bit more sturdier.
That's what I thought. A few days ago a person who said he was head of marketing or something like that made a post on the Bradley smoker fan club page on Facebook .I sent him the same question but never received a response back from him. thanks for taking the time.
Sent from my SM-G930V using Tapatalk
Hello
The piece of sheet metal with the 3 holes in it belongs on the bottom of the door behind the sheet metal face. It acts like a stiffener plate.
Brian.