Author Topic: Got my GURU/RAPTOR today  (Read 1897 times)

Offline ChefBill

  • Jr. Member
  • **
  • Posts: 176
Got my GURU/RAPTOR today
« on: March 28, 2005, 10:48:26 PM »
Well I got my Guru/Raptor today and Wanted to mount both on the top with magnets so I could remove them with ease. I made a right angle bracket that would mount the Guru + the Maverick ET-73 right above itand a magnet at the bottom. Then I drilled the Raptor <i>(That SS is hard as hell)</i> and pop-riveted a magnet to the back of it right at the top. Only problem is the power cord from the BS is too short to reach the top. NO PROBLEM, Just going to get a 6 foot <i>IEC computer cord </i>that will carry 10amps. HA. [:D] Didn’t have to go get one. The cord on the BS was long enough for my computer to UPS and the one on the computer is long enough to put the RAPTOR on top.

The two Magnets I used are the ones that are used for ground cable on an electric welder (about 2-1/2" dia;$3.99ea) with a bolt thru the center. Man they are strong and work great.
I'll post pictures of the finished job as soon as I can get time. Bill

If you can eat it, you can smoke it.
If you can eat it, Then You can smoke it