temp probe??

[dasboat]

Nice I looked at the blue one but just got black one. Where are you guys running the probe wires just through the generator?

[Habanero Smoker]

Black is a good choice; since it was the only option when I purchased mine.  It works out well, since black doesn't show the stains that much.

For the Bradley, it is best to run the probes through the door opening. The lower rack towards the front is the best placement for the pit probe. ThemoWorks also sell an extension wire so you can extend the length of the probe wires if you find a need to do so.

[TedEbear]

Nice I looked at the blue one but just got black one. Where are you guys running the probe wires just through the generator?

Although I haven't used the Smoke with my Bradley yet I previously ran the wires from my old Maverick through the door opening.  The soft rubber doesn't damage the wires and it still makes a good seal.

I also did the glass of ice water test earlier today, as described on the Thermoworks website.  Both probes measured within a few tenths of 32.0 degrees.  I'm happy with that.   

[dasboat]

My smoke just showed up and my victorknox knife 12inch and the wife got me dicks knife so I'm almost ready
New toys https://imgur.com/gallery/5JXZhye

[Gafala]

My smoke just showed up and my victorknox knife 12inch and the wife got me dicks knife so I'm almost ready
New toys https://imgur.com/gallery/5JXZhye

I use a 8" Japanese Damascus Steel Chef Knife love it.

[dasboat]

i just did the ice test and it dropped to 32.5 not sure if i should tweak it or just call it good enough for me

[TedEbear]

i just did the ice test and it dropped to 32.5 not sure if i should tweak it or just call it good enough for me

I think for smoking food a 0.5 degree difference is well within the tolerance.  Did you follow the procedure on the Thermoworks website?

Creating a Properly Made Ice Bath

[dasboat]

i just did the ice test and it dropped to 32.5 not sure if i should tweak it or just call it good enough for me

I think for smoking food a 0.5 degree difference is well within the tolerance.  Did you follow the procedure on the Thermoworks website?

Creating a Properly Made Ice Bath

Yes I checked out  ice made bath from site after someone posted they did that so thought I would check it out and try it to see how far out mine was before starting just to see where it was at

[Salmonsmoker]

i just did the ice test and it dropped to 32.5 not sure if i should tweak it or just call it good enough for me

I think for smoking food a 0.5 degree difference is well within the tolerance.  Did you follow the procedure on the Thermoworks website?

Creating a Properly Made Ice Bath

Yes I checked out  ice made bath from site after someone posted they did that so thought I would check it out and try it to see how far out mine was before starting just to see where it was at

You can also do a boiling H2O test. It will show the accuracy at high temperature. Make adjustments for altitude.