Bookmarks 1 Bookmarks

Author Topic: Looking for lower face plate for my BTIS1  (Read 698 times)

Offline Trisheey1127

  • Newbie
  • *
  • Posts: 1
Looking for lower face plate for my BTIS1
« on: December 24, 2019, 01:22:25 PM »
Does anyone have replacement parts they are willing to get rid of? My dad has a smoker and the control switch broke and we we found out that the circuit board isn’t working and it won’t heat up.

Offline Habanero Smoker

  • Member Extraordinaire
  • ******
  • Posts: 14,739
  • KCBS - Master Certified Barbecue Judge
Re: Looking for lower face plate for my BTIS1
« Reply #1 on: December 24, 2019, 01:37:16 PM »
Hi Trisheey1127;

Welcome to the forum.

As you probably already learned replacement parts for this model are almost impossible to find. If you can't find replacement parts, you may want to look into a third party temperature controller. They can range in prices from the less expensive Inkbird ITC-308 which can control your smoker up to 248°F (which is all that you need) or go to the higher end Auber Instruments which gives you more options and tighter temperature control.

These type of controllers let you bypass the smoker's controller.


Offline dubob

  • Newbie
  • *
  • Posts: 78
Re: Looking for lower face plate for my BTIS1
« Reply #2 on: December 25, 2019, 07:11:07 AM »
I have used the Auber PID Controller for about 10 years now.  I wouldn't have a Bradley smoker without it.  It controls the cooking temps +/- 1 degree and I can program up to 6 steps in any smoking recipe.  I use 3 for smoking fish at 3 temps and different times for each temp.  Excellent results every cook.
Bob Hicks, from Utah
I’m 77 years young and going as hard as I can for as long as I can.
“Free men don't ask permission to bear arms.” ― Glen Aldrich
“Be who you are and say what you feel, because those who mind don't matter, and those who matter don’t mind.” ― Dr. Seuss