Text only | Text with Images

BRADLEY SMOKER | "Taste the Great Outdoors"

Bradley Smokers => The Black Bradley Smoker (BTIS1) => Topic started by: Montcoyote on January 16, 2010, 08:18:10 PM

Title: Placement of an installed PID sensor
Post by: Montcoyote on January 16, 2010, 08:18:10 PM
Hello all...newbie here (lots of new Christmas Smokers out there!).

I have a new OBS. After a few smokes in cold temperatures, I have ordered the materials to do the second element install. I also ordered an Auber controller with the temperature sensor that you permanently install.

I ran a few searches, but could not locate a post with installation instructions for the Auber probe. Also, I'm not sure of the best location for the probe.

Thanks in advance!

Title: Re: Placement of an installed PID sensor
Post by: classicrockgriller on January 16, 2010, 09:04:53 PM
I think it just a holder that gets screwed in the cabinet.

Placement I would say no higher that the second rack.

Mine is mobile.
Title: Re: Placement of an installed PID sensor
Post by: JF7FSU on January 16, 2010, 09:11:28 PM
Auber provides detailed instructions for mounting the probe on their site.  It involved one drill hole through the back of the unit from the inside out.  They recommend mounting it just below the top rack in the middle.  You drill a small hole, push the probe through and screw the cap on the back and it is all done.  Took me 10 minutes including set up and packing up. 
Title: Re: Placement of an installed PID sensor
Post by: classicrockgriller on January 16, 2010, 09:24:51 PM
You want your probe just below the meat of your lowest rack cooking.

IMO I would put it below the second rack from the bottom.
Title: Re: Placement of an installed PID sensor
Post by: love the smoke on January 17, 2010, 06:06:13 AM
http://auberins.com/images/Manual/Wallmount%20sensor.pdf (http://auberins.com/images/Manual/Wallmount%20sensor.pdf)

LTS

Just did mine also took no time at all
Title: Re: Placement of an installed PID sensor
Post by: Montcoyote on January 17, 2010, 06:58:44 AM
Thank you all!

I didn't think to look on Auber's site. I should have it installed by lunch, if I can keep the kids from running into the street.

Title: Re: Placement of an installed PID sensor
Post by: anderson5420 on January 17, 2010, 07:15:03 AM
Obviously whoever wrote the Auber sensor installation instructions is better with electronic instruments than with the English language...
Title: Re: Placement of an installed PID sensor
Post by: pensrock on January 17, 2010, 07:22:15 AM
For some odd reason Auber say just below the top rack, I do not understand that. I put mine about the middle of the tower.
Title: Re: Placement of an installed PID sensor
Post by: drano on January 17, 2010, 12:22:42 PM
I've got the permanent installed one also. 
I put it between the middle 2 racks.  Wish I would have mounted it higher (real close to the bottom of the rack above it) because if I set a big butt/brisket on the rack where the probe is, the meat will hit the probe. 
Solution is simple though, drill another hole to move it , and plug the old hole with a bolt.
Some day I might move the probe between the bottom 2 racks, keeping it under the lowest meat as others suggest. 

get smokin
drano
Text only | Text with Images