Hello all!!
I just got a new BDS and am wanting to find out more about getting the heat to recover quicker. I have seen a lot of discussion around adding another 500w element and a little comment here and there about putting a 900w element in. My question is- Can one change out the 500w for a 900w element without performing any serious modifications or do you have to do modifications to accommodate the 900w element?? Also where would you get a 900w element?
Thanks
Hopefully someone will come by that's done The 900w mod. I did the
500w as a mentioned on the thread.
Sent from my iPhone using Tapatalk
Thanks a bunch!! Hopefully there is someone out there who has done it.
Are you satisfied with the extra 500w element and was it hard to do??
There is not a whole lot of modification needed to install the 900w element. You will need to add a couple brackets to hold the element in place.
You can get the element here...
http://www.grainger.com/Grainger/TEMPCO-SS-Heater-2XEF3?Pid=search
Here are some pictures of the element installed...
(http://i752.photobucket.com/albums/xx169/muebe/IMAG0593.jpg) (http://i752.photobucket.com/albums/xx169/muebe/IMAG0594.jpg)
Quote from: Fooser2006 on March 19, 2012, 07:58:48 PM
Thanks a bunch!! Hopefully there is someone out there who has done it.
Are you satisfied with the extra 500w element and was it hard to do??
Works great. Smoker pre heats in about 10 minutes. Hardest part is notching out the ceramic holders. If you have a dremmel tool it's a bit easier. I used a coarse cone shaped stone attachment. It's all I had that would work.
Sent from my iPhone using Tapatalk
Does the standard bradley digital controller power the 900w element ok or do you have to use a different type of PID?
How long have you been using the 900 watt heater? I wanted to convert mine, but I was concerned that the 900 watt heater needed moving air over it.
Hi,
I did the 900w upgrade and love it. You can get one from McMaster Carr on line and they will ship it to your house. It does NOT need a fan blowing over it. I would get the one with fins for better heat dissipation in your cabinet. Not sure about your PID with that model Bradley, I have an OBS and installed a PID and a solid state relay to power the heat element. There are some really helpful diagrams on here some where that will help you rewire your smoker.