Hello, I am new so sorry if this has been asked before!
Will the Bradley Digital Smoker Replacement Smoke Generator fit the original BTIS1?
here is the part:
http://www.yardandpool.com/bradley-digital-smoker-replacement-smoke-generator-generdigi?gclid=Cj0KEQjwsIWvBRCnzevvor2g4L8BEiQAAN234fHwl1KAUK9Ps-Aq1KpMvCX8AVEISqX0xmS7H5c6WJ4aAkHx8P8HAQ
if I may ask, what are you trying to accomplish? If your OBS generator is working, you will probably end up with the similar capabilities by using the money and buy an Auber PID or similar. You will end up able to time your cooks, maintain temps but also have the advantage of holding tighter temp ranges
If you want to use this smoke generator with the tower you have, it will not work unless you buy a pid as GusRobin said OR changing the sensor in the back panel of the tower. The digital smoke generator needs a digital sensor, digital plug and digital cable to work without a pid. Everything can be bought but would be easier buying a pid.
After second thought, if you own a BTIS1 (NOT the one with smoke design on the door) and your slider bar below the door is still good, you may be able to use a digital smoke generator with it as long as you buy this plug with it. http://www.yardandpool.com/bradley-cold-smoke-adapter-by-pass-plug
The reason is because the BTIS1 has a controller in the tower itself unlike the new original smoker (now called BS611). You just have to plug the tower into the wall and NOT into the digital smoke generator. You would control the heat with the slider bar and your smoke generator with the little plug that i gave the link. Just remember, ONLY the smoke side will work. Hope I'm clear enough :D
TY! good to know it will fit. Just works a little different :)