Hello,
Recently purchased a digital 4 rack smoker, and used it a few times. nearly every time at some point during the process a puck will "hang up" and not drop down when the pusher tries to advance a new puck through. it starts to drop down but then the pusher slides back under it and lifts it up the chute again. This means that if I don't keep checking the smoker every 20min I could ( and have ) end up with a puck burning for over an hour, and setting the next one on fire, obviously this could end up setting the whole thing burning.
Any ideas how to solve this so I can set it to smoke and leave it going?
Thanks.
welcome aboard.
the long tube that the pucks are in.. be sure that it is all the way down,,, if it is not .. it will create some extra wiggle room on the pucks not allowing them to fall properly,...
also check to see that the puck pusher is retracting all the way back beyond the drop point of the pucks,, if not it has to be adjusted.
check for any thing blocking the pucks from dropping properly... debris. dropping from the pucks,,, sharp edges... ect...
hope this helps
Here is a link to some additional troubleshooting tips, with pics. The first part talks about the alignment of the feeder tube.
Why won't my bisquettes advance when I push the Advance button?
(http://www.susanminor.org/forums/showthread.php?488-Answers-To-Bradley-Smoker-FAQ-s&p=777#post777)
Thank you all, I will try the suggestions and report back.