The burner inside my smoker is not working...the indicator light on the front is not on telling me i have no power?...
it is not that old? can the burner be shot?
Any ideas?
cheers
Welcom twinwinds.
There can be several reasons it is not working. You should go the the recipe site and look over the FAQ section. I think there is a troubleshooting guide there.
Is your smoker an original or digital?
1) Check all connections carefully. Push the cords into the sockets firmly, even give them a wiggle. There have been several times when good contact was not being made.
2) If an original unit when you move the heat control slider the whole way to the max position, try backing it off a little.
3) Is there a blown fuse in the smoker?
4) If original, it could be a bad board, where the slider is.
5) It could be a defective over heat cut out.
If it turns out to be 4 or 5 Bradley service is great and can help out quickly.
More members will be stopping in to give suggestions.
pens hit it right on the head,,,
check all connections ... one last thing be sure that you have power to the unit ( IE pluged into a recptical that has power to it ) I know this sounds silly though you may have tripted a breaker and no power at the bradley
Thanks for the input. I tried everything you suggested, had it all apart and made sure connections were good and i do have power as the puck feeder works fine.
cheers........