Just got my maverick setting it to smoke pork butt. set to what instructions said. transmitter giving out smoke house temp and butt temp. receiver giving out none just flashing. is this normal? all help welcome.
OS
I always turn on the transmitter then the receiver but do it at the same time or close to it. It sounds like the receiver just isn't getting the signal. Try turning both off and start again.
Mike
Thanks MIKE. did what you said work great. had to get a maverick seems that all use it and love them.
OS,
great choice on the maverick.
i usually will not buy an accessory for my toyools till check with the people
here.
if they won't use it i can't choose it! :)
If I remember the instructions I think you only have a 30 second or so window to activate the receiver after the transmitter is turned on, so have them both side by side. Hope this helps.
Quote from: Smokin Soon on April 11, 2009, 06:32:31 PMIf I remember the instructions I think you only have a 30 second or so window to activate the receiver after the transmitter is turned on, so have them both side by side. Hope this helps.
That sounded strange to me so I dug out the instructions for my Maverick ET-7. They say, "... switch the receiver to OPERATE (IMPORTANT: The receiver must be turned on before the transmitter) and then within 60 seconds switch the transmitter ON." That's probably the reason I took a Sharpie and put "1st" on the front of my receiver.
Seems to me it would be the same for the ET-73.