BRADLEY SMOKER | "Taste the Great Outdoors"

Recipe Discussions => Meat => Topic started by: mlp311 on November 06, 2011, 02:33:43 PM

Title: Butt help
Post by: mlp311 on November 06, 2011, 02:33:43 PM
I've had 3 butts in for 16 hours now and the bottom one is just now at at 178 degrees and top is at 162. Would it be ok to pull the three and FTC for several hours? I want to pull them. Im wanting to pull them because I have 2 chickens to do too and am running short on time.
Title: Re: Butt help
Post by: mlp311 on November 06, 2011, 02:44:16 PM
Sorry, a lot of pulling there, but I want to do pulled pork with the butts.

Sent from my DROID3 using Tapatalk
Title: Re: Butt help
Post by: Wildcat on November 06, 2011, 02:49:15 PM
You did not indicate what cabinet temp you were cooking at. If it was at 200 to 205, the one that is 178 can be pulled. If you are cooking at a cabinet temp of 210 or higher I would recommend taking the butts up to at least 190 before you stop cooking.
Title: Re: Butt help
Post by: viper125 on November 06, 2011, 02:51:03 PM
If it was me I'd put them in the oven  and finish while doing the birds. Probably wrap the butts in foil and add some apple juice.
Title: Re: Butt help
Post by: squirtthecat on November 06, 2011, 02:52:35 PM
Quote from: viper125 on November 06, 2011, 02:51:03 PM
If it was me I'd put them in the oven  and finish while doing the birds. Probably wrap the butts in foil and add some apple juice.

Ditto. 
Title: Re: Butt help
Post by: mlp311 on November 06, 2011, 03:01:37 PM
Thxs, to the oven they will go. I don't know if I've got element issues or what, but I can't get the temp up. I've opened door twice today to refill water pan and just now got up to 210. My temp adjuster has been on high the entire time. I've had top vent open maybe 1/4 closed. Should I close vent more? Am I doing something wrong?

Sent from my DROID3 using Tapatalk
Title: Re: Butt help
Post by: viper125 on November 06, 2011, 05:34:13 PM
Well I never go much higher. But a red brick or two added to the smoker will help heating. I keep vent open all the way. Make sure you use hot water in bowl. Use a remote thermometer something like a Maverick 732. That way you don't have to peek. That makes it never go up. LOL Im going to do the mod and install a second heating element. That will improve it to where it should heat up in ten minutes or so. But you should use a Auber PID to control then.
Title: Re: Butt help
Post by: Wildcat on November 06, 2011, 05:45:59 PM
3 butts is a large load and will tend to keep your cabinet temp kind of low until the latter part of the cook. If the vent is not open enough this will keep the temp lower also. I prefer to cook butts at 200 to 205 and 2 butts normally take about 24 to 30 hours to cook. Nothing wrong with taking that long - the end results are great. In addition, I do not get stuck with much honey do's because I have to monitor my smoker to make the food taste good. If you do not want to spend that much time, then I would suggest that you simply do the smoking in the BS and tranfer your food to your over for the remainder of cooking.
Title: Re: Butt help
Post by: mlp311 on November 06, 2011, 07:31:25 PM
(http://i1107.photobucket.com/albums/h387/mlpayne31/photobucket-2450-1320636594609.jpg)

Sent from my DROID3 using Tapatalk
Title: Re: Butt help
Post by: mlp311 on November 06, 2011, 07:32:21 PM
(http://i1107.photobucket.com/albums/h387/mlpayne31/photobucket-2239-1320555086736.jpg)

Sent from my DROID3 using Tapatalk
Title: Re: Butt help
Post by: mlp311 on November 06, 2011, 07:37:53 PM
Thanks for the help. I don't mind spending the time, but I was just counting on 12 hours for some reason. This was only my second smoke, so im learning as I go. Everything turned out great. Just moved the chickens inside to the oven to crisp the skin, and thanks to you all's advice I was able to stay on schedule. I will allow more time for the butts next go round. Thanks again.

Sent from my DROID3 using Tapatalk
Title: Re: Butt help
Post by: Wildcat on November 06, 2011, 07:55:50 PM

Both the chicken and butts look great! When it comes to butts and brisket, allow plenty of time. If they get done too early, it is possible to FTC for several hours until serving time. They are also fairly easy to reheat.
Title: Re: Butt help
Post by: mlp311 on November 06, 2011, 08:17:26 PM
(http://i1107.photobucket.com/albums/h387/mlpayne31/photobucket-1235-1320639356755.jpg)



Sent from my DROID3 using Tapatalk
Title: Re: Butt help
Post by: mlp311 on November 06, 2011, 08:21:51 PM
(http://i1107.photobucket.com/albums/h387/mlpayne31/photobucket-864-1320639336481.jpg)

All turned out great. FTC the butts for a few hours and just finished pulling. These are going to have to be good reheated, they are for lunch at work tomorrow.

Any advice on reheating everything. What temp and how long do I need to allow. I split the three butts into two containers. Do I need to cover the chicken with foil before putting back in the oven?

Sent from my DROID3 using Tapatalk
Title: Re: Butt help
Post by: GusRobin on November 06, 2011, 08:30:41 PM
I have made butts for work and what I did was reheat in crock pots. If that doesn't work for you, I would put in a covered foil pan with some beef broth and reheat at 350.
Title: Re: Butt help
Post by: Wildcat on November 07, 2011, 08:02:50 AM
If you vac seal then you can also reheat in the sealed bag by placing it in hot water. Just do not let the water boil as the seal might break. Another option is the microwave. You can also use apple juice when reheating by the methods that GusRobin mentioned.
Title: Re: Butt help
Post by: mlp311 on November 08, 2011, 04:35:24 PM
Thanks for everyones' help. The butts were good and the chicken was out of the park delicious. Was my first experience using a brine on the chickens, and it made a huge difference.

Sent from my DROID3 using Tapatalk