I am assembling a PID for the OBS using a REX-100FK02-V*AN N and Fotek SSR-40 DA relay. I am struggling with the wiring and have been unable to find a diagram for this particular PID. I have Rob's write-up. Meanwhile my question is whether or not the K thermocouple provided can be installed in the Bradley, and if so where, or should a different type of probe be used. Any help will be appreciated.
I have an Auber SYL-2352 (http://www.auberins.com/index.php?main_page=product_info&cPath=1&products_id=3) PID controller in my Bradley OBS. I use an Auber K-type TC with an alligator clip and attach it below the lowest rack of whatever I'm smoking. I run the wire through the top vent.
K Type Thermocouple w/ alligator clip tip (http://www.auberins.com/index.php?main_page=product_info&cPath=20_3&products_id=275)
(http://www.auberins.com/images/TC-K6A2a.jpg)
Thanks TedEBear, I like the alligator clip mod :)
Quote from: TedEbear on April 09, 2015, 09:18:40 AM
I have an Auber SYL-2352 (http://www.auberins.com/index.php?main_page=product_info&cPath=1&products_id=3) PID controller in my Bradley OBS. I use an Auber K-type TC with an alligator clip and attach it below the lowest rack of whatever I'm smoking. I run the wire through the top vent.
K Type Thermocouple w/ alligator clip tip (http://www.auberins.com/index.php?main_page=product_info&cPath=20_3&products_id=275)
(http://www.auberins.com/images/TC-K6A2a.jpg)
Have you placed the PID controller within the smoke generator housing?
I will be enclosing the PID in a separate housing
Quote from: Divey on April 09, 2015, 05:38:34 PM
Have you placed the PID controller within the smoke generator housing?
Since you quoted something I posted, I'm assuming you're asking me. Yes, I have my PID in the SG.
(http://i23.photobucket.com/albums/b355/roadijeff/Food/IMG_0594_zpsfd6577ea.jpg)
(http://i23.photobucket.com/albums/b355/roadijeff/Food/PA070029_zps9d0b3d85.jpg)