My 2 year old BTDS108P started acting up. When the generator is plugged in the screen will make 1 little flash every few seconds along with an audible "click". The generator will not power up at all.
Any suggestions?
And it's not any kind of pattern that flashes on the screen
Sounds like you have power to the smoke generator. I think I'd start by taking the shroud off the smoke generator and looking for a wire that is disconnected or loose. Since the display is acting wonky, I'd look there first.
I'm guessing that the clicking is the puck pusher. You might give that a once over, too. To make sure it cycles properly and isn't binding on some obstruction.
When you go to take the shroud off the smoke generator, remember that you only need to remove the screws around the perimeter of the bottom. The screws in the center of the bottom hold components in place.
If you don't find something obvious, I'd make a call to Bradley customer service for some diagnostic assistance.
Sound advice.
Quote from: AlbertaAdvantage on October 07, 2017, 07:59:12 AM
My 2 year old BTDS108P started acting up. When the generator is plugged in the screen will make 1 little flash every few seconds along with an audible "click". The generator will not power up at all.
Any suggestions?
I just had that problem yesterday and I had a loose AC plug.
Make sure all plugs are pushed in securely.