• Welcome to BRADLEY SMOKER | "Taste the Great Outdoors".
 

E1 Error

Started by captainkm, September 12, 2010, 12:31:14 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

captainkm

Hi everyone, hoping all of you are having a great weekend.

Has any of you ran into an "E1" error when you turn on eather the oven or the smoke side of the DBS?

I checked all the wiring twice over, they look good.  While the "E1" is beeping I checked the tray (that pushes the puck through) and the heating tray (for burning the puck) they both are working.

Any suggestions?  ???


classicrockgriller

E-1 is usually caused by a bad connection on the temp sensor

wire between the cabinet and the smoke generator.

Q. Why does my Digital Bradley Smoker starts OK then beeps and displays an E1 error on the screen?

A. The E1 error is usually an issue with the TC wire (small wire between generator and tower). If you unplug and re-plug it a couple of times or even unplug and reverse it, it will usually help. I found that the problem only happened a couple of times. Once I had unplugged and re-plugged a couple of times it seemed to resolve it. It was almost like it had some rough cast plastic in the pin part of the connector or something.

Additional Information from the Bradley website:
An "E1" message is something to do with the sensor cable. The sensor cable is the short skinny cable that runs from the generator to the tower. Please make sure that it's connected, secondly unplug it and switch the ends around, so plug "A" side into "B" and the "B" side into "A" sometime that makes a better connection. Also make sure that is nothing blocking that connection ie: loose chips, dust (using a piece of steel wool or super fine sandpaper to clean the ends of your sensor cable works well).

Also; while the generator is on and the "E1" error is displayed and beeping, check the connection by wiggling one side of the connection up and down and left to right, and then the other side. If the "E1" message temporally goes away while you were wiggling one side, you need a new sensor connector.

If none of the above actions work, the E-1 error may be a bad connection to the temp sensor the connection is located in the back of the smoke tower remove the back of the smoker and check the connection.

You can find alot of good infomation here:

You might want to check out our FAQ's
http://www.susanminor.org/forums/showthread.php?481-Bradley-Smoker-FAQ-s&p=748#post748

captainkm

Thank you CRG, that was it.  I can get back to one of the better things in life, "smoking" ;D

Thank you again!!