build up of used bisquettes, what to do?

Started by jonnypwa, February 20, 2013, 09:34:20 AM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Tenpoint5

For the most part the VENT issue has been beaten to death. If you can't figure that one out.

As for the smoke times 99.9% of the people on here NEVER use more than 4 hours of smoke in their cooks. I myself have used 8 hours of smoke BUT I was also smoking and curing a 28 pound ham from scratch. I was a 36 hour cook. Listen to the advice that you are hearing. It is good advice, it is offered freely, and it comes from a WHOLE LOT of experience!
Bacon is the Crack Cocaine of the Food World.

Be careful about calling yourself and EXPERT! An ex is a has-been, and a spurt is a drip under pressure!

classicrockgriller

Opening the vent on your Bradley is not something the guys on the Bradly Forum invented.
It is a known fact in the Smoking community. Does the vent have to be wide open? No sir, but it should be open enough to allow the smoke to pass by the meat you are smoking and to remove moisture the meat in your smoker is creating. Most of the people on this Forum have had success with an open vent so they just leave it wide open or maybe 3/4 open. For me I took the vent adjuster off my smoker long ago.

This is from the web site "The Grilling Spot" and it has no affiliation with Bradley Smoker

"Question - During meat smoking, when is the smoke absorbed?
Most of the smoke is absorbed in the first hours of smoking as most of the juices are later lost and the meat 'caramelizes'. Less smoke is absorbed during the latter part of smoking.
Some meat smokers have a chimney to convey excess smoke out while others simply have vents or dampers or a combination of both. The main focus in smoker cooking is for the smoke to encompass the food as it cooks, the food gets a 'smoke bath'. Not too much, just enough to flavor your meat. Allow the air in the smoker to circulate, crack open the vents for smoke to escape. Do not allow the smoke to stagnate. Maintain a 'smoke-flow'."

That should be a "No Brainer" Vent open equals Good, Clean Smoked Meat.

Now length of time to smoke something is entirely up to the person smoking the meat and the people eating the smoked meat. I personally like smoke. Butts, I smoke 6 hours plus, Briskets will get 5 hours plus and my plus is usually 2 to 3 more hours. I also know that meat stops asborbing smoke somewhere in the 140 internal temp at a 1/4 deep into the meat. So all the extra smoke after that is just feeding the bark.

Last thing I will say is, You bought and paid for your Bradley and you are entitled to cook with it any way you want to. If you screw it up by smoking with closed vents, then you have nobody to blame but yourself. And if you are trying to preach a new way of smoking with the Bradley, I don't think you will get any followers.

My $0.02. Good Luck to Ya!

jonnypwa

Great advice guys, will be moving my smoker out to the back yard tomorrow to give it a go with the vents open, been smoking indoors under a extraction canopy which was fine with he vent closed but ill certainly be changing my methods to see the results,

I can see some great points that never even crossed my mind, I have done plenty of chef work but never realized that the smoke changes some of the aspects from a usual oven technique.

I have however already bought a cold smoke adapter, although i'm not going to use it straight away does anyone know what cable i need to fix the generator to the oven as i only have the one that came with the machine and it wont reach as obviously the cold smoke adapter normally would require any heat,

I am goign to try and set up a permanent fixture that allows me to do both hopefully

Thanks again guys amazing advice

JP

Tiny Tim

#18
The cold smoke adapter will have a "dummy" plug included, that plugs into the back of the SG where the small cable would plug in.  As it is a cold smoke attachment, the theory was that you weren't going to be using the heating element, but the digital SG won't run smoke unless it thinks the tower is getting power.  There is a thread around here somewhere on where to get a longer sensor cord, I'll look around and see if I can find it.

Here it is (click this sentence).