PING. Devo and Nepasmoker

[Tenpoint5]

Don and Rick:  I found this during my travels. I thought of you guys right away!

Harvesting mold from commercial salami

mold is traditionally used as a preservative on cheese and salami, but the mold must be the 'right' mold. There are thousands of mold strains and several of these produce poisonous or carcinogenic toxins when growing. They can also spoil the taste of the product. The chance of getting the right mold strain spontaneously when drying a salami is actually very small.

To make certain that the right mold is produced, one should inoculate. This is no more strange than adding yeast to a bread dough or homemade beer. There are mold cultures that can be bought from the Internet, but the cheapest and most natural method is to harvest the mold from a commercial salami. That gives a possibility to select the culture from the whole array of available products. The mold is responsible for much of the aroma of the final product, so here is the opportunity to adapt one's product to one that is already on the market.


Method:

Choose a salami with live mold. Live mold looks white and chalky. You only need the skin. Maybe you can get the skin for free in your deli. You will need a patch the size of a stamp. Patches of skin can be stored refrigerated in a sealed jar for later use. They will keep for months.

Bring half a cup of bottled or otherwise unchlorinated water to a boil (to sterilize). Add one teaspoon sugar. Let cool to body temperature. Add the salami skin patch. Cover and let stand in room temperature for 6-12 hours. Discard the skin. Dilute the solution with sufficient unchlorinated water to fill an atomizer.

Immediately after stuffing, spray generously of the solution onto your salami (the solution should not be added to the stuffing!). Hang the salami to ferment according to the instructions in your recipe. The conditions for fermentation are also ideal for the mold growth, i.e. 20-27 C/68-80 F and 90+ % relative humidity (these conditions can be attained in different ways; I use a disconnected refrigerator with door closed and a hung up wet terry towel). Repeat spraying the solution onto your products a few times during fermentation. Avoid touching the skins. The sausages must hang freely or else the mold will not cover them totally.

After 2-3 days, depending on temperature, you should be able to see a diffuse greyish coating on the casings. This is the mold. Probably by now, the fermentation is ready too.

The salamis can now be moved to the drying chamber. The mold will be fully grown after about a week. Until then, avoid disturbing it. When full-grown, the mold is extremely resistant and the salamis can be touched with bare hands.

Note: If black or dark grey spots appear during the first days, brush them with a little distilled vinegar. These spots of unwanted mold strains tend to form around specks of dirt or dust and can be avoided by keeping good hygienic standards during stuffing.

[Saber 4]

Good read, thanks for posting Chris

[NePaSmoKer]

I already knowed this cuz i knows everything    :D

[devo]

I already knowed this cuz i knows everything    :D

X2  ;D

[tailfeathers]

NePa went to school and said
Durn! I growed another head!
Teacher said it's time you knowed,
the word is grew instead of growed!
(With apologies to Shel Silverstein)


Sent from my iPhone using Tapatalk

[iceman]

I already knowed this cuz i knows everything    :D

Did you know you could save 15% in 15 minutes with?  ;D  ;)