Smoke Generator Adaptor for Propane smoker

mbetz · December 13, 2009, 07:59:38 AM

Well my smoke generator arrived this week. Yesterday I had some time while my daughter was taking a nap this is what I got accomplished. I used some 3/4" plywood I had laying around. I intend on adding some feet to the bottom of the box still. After the feet are added I will locate and mount the other PVC flange to the side of my propane smoker cabinet. I still intend on finishing the outside of the box to help protect it from the elements. I will post more pictures when it is complete. I will probably be after Christmas.

Picture of the adapter box without the generator attached.

Picture of the adapter box with the generator attached.

Picture with the access door. As you can see I have some foam seal in the inside of the access panel.

Picture with the access door closed.

Tenpoint5 · December 13, 2009, 08:06:31 AM

Nice looking box!! I would watch out mounting the flange permanently to the side of the cabinet. One would think it will interfear with the normal SG being mounted and used for normal smoking

Hopefull Romantic · December 13, 2009, 08:58:03 AM

nice

mbetz · December 29, 2009, 03:20:06 PM

Well I we got back from our vacation and I found some time today to finish adapting the smoke generator to my propane smoker. Below are several images of the finished project.

I finished the wood box with a cutting board conditioner and I painted the PVC with the fusion spray paint.

Enjoy the pictures. I am going to give the finish a couple of days to cure before I give it it's first test run. I will let everyone know how it goes.

Happy Holiday's

Mark

KevinG · December 29, 2009, 07:38:24 PM

That came out nice Mark - can't wait to see it full of smoke.

djkost · October 22, 2010, 08:43:08 PM

Say where did you get the adaptor for the smoke generator? I need on also cause I have a small wood stove that would work to connect to the smoker.

mbetz · October 24, 2010, 06:16:21 AM

I made this adapter from some scrap wood I had around the house. Then purchased some PVC to connect it.

SouthernSmoked · October 24, 2010, 04:04:23 PM

Nice!

BuyLowSellHigh · October 24, 2010, 07:12:55 PM

Very impressive use of the Bradley SG, and very nice craftsmenship.

Quote from: mbetz on December 13, 2009, 07:59:38 AM
... Yesterday I had some time while my daughter was taking a nap this is what I got accomplished. I used some 3/4" plywood I had laying around. ...

Okay, I have a question ... how long are your daughter's naps?