Circulation fan install

[RonR]

Hi guys, I purchased the motor and the 2 fan blades from grainger.  I hope I can figure out the reversible part.  I was wondering something,  on that motor both wires look the same.  Is the top wire(closest to the shaft) or the bottom wire (farther from shaft) the Hot wire?  Also, for a CCW installation what way should my set screw be facing on each fan blade? Thanks for the help.  I'm sure i'll have lots of question on this mod.  I have read everything I can find in this forum on the install.  Doesn't mean I have a grasp of it all though.  :P  Thanks

[Mr Walleye]

Hi Ron

Here is a thread I discribed how I changed the motor to CCW. It's about halfway down the page.
http://forum.bradleysmoker.com/index.php?topic=4437.0

As far as the wires go I don't think it matters which way you hook them up, as long as one of them is not hooked to the ground.

Mike

[iceman]

If you take a look at the thread MW posted it will answer most of the questions you might have. These guys are great at the 101 courses. ;D There is a lot of help on this forum so if you have questions by all means fire away. You're bound to get the help you need. ;) :)

[NePaSmoKer]

How will the fan work with my PID?
Will it throw the numbers off?

nepasmkr

[Mr Walleye]

I don't have a PID but from what I understand if you added the fan you would want to run the autotune again. Hopefully someone will chime in who is running both a fan and PID.

Mike