New product on the market

[Toker]

For the sausage and jerky lovers and also useful when hanging things like bacon.
https://www.auberins.com/index.php?main_page=product_info&cPath=14_93&products_id=850

[manxman]

Interesting, takes me back a few years when several forum members advocated the addition of a fan to the Bradley Smoker in a similar fashion to those that advocate dual heating elements. Seem to remember there were plans on this forum for a DIY fan installation?

Auber ship internationally, I had a PID for my Bradley shipped to the UK and thoroughly recommend them. Thanks Toker  :)

[Toker]

I remember it too [emoji16]. I was one of them [emoji57]

[manxman]

"I was one of them"

Did you ever get a DIY version working satisfactorily?  :)

Suppose it could be useful to get some air flow to assist pellicle formation prior to cold smoking the likes of salmon etc as well?

[Toker]

At the end, I've found it more works to installed tan good cooking results. In others words, not so worthy.

[Toker]

Here's a couple of pictures of the fan installed

[TMB]

Interested to see how this unit works and holds up over time

[Toker]

Sorry TMB just finished the installation did not have time to test yet.

[TNRockyraccoon]

Any feedback on how it's working?

Definitely looks like it could move plenty of air. Looks like an easy install job as well.

I did a fan mod on my OBS several years ago, where everything but the blade was on the back of the cabinet.....but that blade and shaft were constantly gooped up and I eventually quit using the fan for most of my smokes. I found it worked ok when the load was light, ie. almonds, a few racks of jerky, salmon etc. Not so well with heavy loads like a pork butt or whole chicken. I just don't think it moved enough air.

[Toker]

Like a charm surprisingly [emoji16] even the probe on the door became accurate [emoji23]and compared to the fan you're talking about ( I have one of those too [emoji16] ) the installation was a breeze [emoji16]

[jpowers40828]

I installed the same one, it was very simple. The only thing i did differently than the instructions was take off the rear panel and use a large washer instead of securing the fan to the panel.