« previous next »
Pages: [1]   Go Down

Author Topic: Dual Probe PID Help  (Read 2928 times)

Offline VI_Smoker

  • Newbie
  • *
  • Posts: 67
Dual Probe PID Help
« on: June 06, 2010, 07:38:13 am »
Hi,
I'm using a dual probe Auber PID for the first time and have a question.  When should the Smoker Generator turn on? Both the R1 and R2 parameters are set to 1 but the SG is off.  I have checked the connections and everything is connected correctly and the PID is controlling the cabinet.
Logged

Offline BuyLowSellHigh

  • Member Extraordinaire
  • ******
  • Posts: 2,354
Re: Dual Probe PID Help
« Reply #1 on: June 06, 2010, 08:26:24 am »
Don't take this the wrong way but, are you sure the SG is switched on ?  If so, check the SG power output of the Auber.
Logged
I like animals, they taste good!

Visit the Recipe site here

Offline VI_Smoker

  • Newbie
  • *
  • Posts: 67
Re: Dual Probe PID Help
« Reply #2 on: June 06, 2010, 08:40:32 am »
Hi BLSH,
yes the SG power is on, the sg light on the pid is off and the sg switch light is also off, i.e. it looks like the pid is not sending power to the sg.
Logged

Offline VI_Smoker

  • Newbie
  • *
  • Posts: 67
Re: Dual Probe PID Help
« Reply #3 on: June 06, 2010, 03:06:11 pm »
So it turns out the problem was the power cord  - I went out and got a 12 guage cord and the problem is resolved.

Thanks
Logged

Offline TestRocket

  • Member Extraordinaire
  • ******
  • Posts: 2,530
Re: Dual Probe PID Help
« Reply #4 on: June 06, 2010, 03:18:31 pm »
Current draw... thanks for posting the solution!
Logged
Pages: [1]   Go Up
« previous next »