Who would I get ahold

[Jkwellborn]

I need to get a bolt and nut for the heat plate on my smoke generator. I'm assuming its just stainless steel. I haven't called CS to make sure. They would be the ones to contact to make sure I get the right part, right?

[Habanero Smoker]

If you take one of the bolts to a hardware store, such as Lowes, Home Depot, Ace, or other, you may be able to find a match. When you take the bolt to match it up, place the bolt in a sealable plastic bag. I can't tell you how much hardware I've lost by just putting it in my pocket without placing it in a bag first.

[RFT]

Hey bud. great to see you here. 

hardware store is your best bet. 

[Jkwellborn]

That's what I had planned on doing. I just didn't know if it was just a stainless setup or adamantium.

[rveal23]

That's what I had planned on doing. I just didn't know if it was just a stainless setup or adamantium.

LOL - Unless you have Wolverine there you should be good with Stainless steel.. LOL

[RFT]

That's what I had planned on doing. I just didn't know if it was just a stainless setup or adamantium.

LOL... A joker huh...  IN that case I suggest 200MPH duct tape.

[Jkwellborn]

That's what I had planned on doing. I just didn't know if it was just a stainless setup or adamantium.

LOL... A joker huh...  IN that case I suggest 200MPH duct tape.

I'm in Texas. We have that.

[Saber 4]

That's what I had planned on doing. I just didn't know if it was just a stainless setup or adamantium.

LOL... A joker huh...  IN that case I suggest 200MPH duct tape.

I'm in Texas. We have that.

Where abouts in Texas?

[Jkwellborn]

Hughes springs. Northeast Texas.

[Saber 4]

Hughes springs. Northeast Texas.

You're about 2 hours northeast of us, we're just outside of Canton.

[Jkwellborn]

I've been there a few times. I need to go to the archery shop down there.