My door will NEVER fall of again

Started by love the smoke, September 07, 2013, 12:47:58 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

love the smoke

Quote from: Saber 4 on October 14, 2013, 07:24:32 PM
Quote from: love the smoke on October 14, 2013, 06:42:12 PM
Just go slow and take your time, the metal is very thin and easy to strip out
No pre drilling needed


Would you say it's to thin for aluminum rivets?

I dont know I used screws because I thought it would be to thin for the rivet to "pop" before it pulled through, you could try a few rivets and see what you think ?

Saber 4

Mine is holding up good for now, I just wanted to get your opinion for the future if I have to make a repair like you did. I'll defer to your judgment since you have done it already. Thanks for posting your repair