And another quality problem...

Started by Tominator, July 17, 2004, 06:08:22 PM

Previous topic - Next topic

0 Members and 7 Guests are viewing this topic.

Tominator

Went to load the BS with jerky just now and I see the plastic that is just below the door and houses the heat control is cracked from the inside all the way to the hole the heat control sticks out of.

The unit has not been moved from the table it sits on since my first load of meat. The heat has never gone above 250. Lokking close it appears the screw in the middle is over tightened as it dimples the plastic and the crack goes right through the hole.

Will be calling them AGAIN monday morning[:(]

<font color="red">Where there's smoke....there's meat!</font id="red">

nsxbill

I am beginning to think that the day your BS was assembled, quality control was fishing!  Terrible luck.  I sure hope they are sending free bisquettes to make it up to you for the trouble!

Bill
There is room on earth for all God's creatures....right on my plate next to the mashed potatoes.

Tominator

Yes, Bill, I'm starting to believe it was built on a Monday![|)]

<font color="red">Where there's smoke....there's meat!</font id="red">