• Welcome to BRADLEY SMOKER | "Taste the Great Outdoors".
 

6 Rack Digital BTDS108P in line fuse

Started by Aschenbrenner, June 11, 2016, 11:56:32 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Aschenbrenner

I've just finished modifying my smoker to a 1100 watt element, increased the wire size, installed a fan and hooked up the new Auber. 

All set to go when I found I couldn't get heat out of the element and subsequently determined the inline fuse had failed.

I wonder if I exposed it to too much heat when I moved it from the OEM wiring to the larger range wiring.

Reading some background info I see where at least one seasoned forum member reported running his Bradley without the inline fuse! I'm somewhat of a techno-turnip so would appreciate comments and observations.

I see Lawn and Pool sell the inline fuses rather in-expensively, but by the time I get them shipped into Canada, the price climbs significantly.

Is there an aftermarket fuse that will work from Graingers or a similar Canadian supplier?




Calgary

Cookshack PG1000 pellet smoker :)
Bradley DBS
Weber Genesis

Habanero Smoker

You can order parts directly from Bradley. Just call their customer service, but I would suspect you will blow the fuse again.

Did the inline fuse fail immediately? How hot did the cabinet get before you noticed the element not working? I see you have a PID. My feeling is, if you can have redundant systems, then that is better than one. I've seen more than one post, in which the PID has failed during operation.

I've noticed some confusion about the inline fuse that are in the Bradley. I believe the in-line fuse in the Bradley is an electrical fuse, and not a mechanical one which works by heat. But I'm not absolutely sure.

If it is electrical, and the stock wiring of the Bradley is 14ga, the inline fuse will have a 16ga wire in it, so if too many amps/voltage is flowing through the wire, that the fuse will blow before any damage can occur to other components. Adding an 1100 watt element (in addition to the fan), even though you increased the wire size, the inline fuse is the same, and it can't carry the increase load. Again; if it is an electrical fuse, it would be better to look for a fuse that is designed to carry the load of an 1100 watt element, that is consistent to your upgraded wiring.

If the inline fuse is a mechanical fuse, then it is worth installing a new one, and make sure you set your PID no higher that 250°F - 275°F.



     I
         don't
                   inhale.
  ::)

Aschenbrenner

Calgary

Cookshack PG1000 pellet smoker :)
Bradley DBS
Weber Genesis