i have obs and have only used it once went to use it today and the smoke generator dont work. it cycles the pucks like normal but it aint burning them they slide out unburned any ideas??
Did you check the 15 amp fuse located at the back of the generator? Could be a bad puck burner element....I am sure someone much smarter than me will be able to help you ;)
The pushing machinery is independent of the burner. The connection to the heating element may be loose. Open up the generator and follow the wires coming out of the tube under the burner plate.
yes checked the fuse its good
ok will try that thanks
well checked all the wireing could not find anything loose the fuse aint blowen must just be a bad smoke generator :'(
Well this would be the first faulty SG I have heard of. If you go the the recipe site there is a trouble shooting post on there that should help you.
It does seem like a loose wire. Even if the wires that go to the bisquette burner look connected, unplug them and then reconnect them. If the bisquette burner was bad, it will generally blow the fuse on the back of the generator.
Bradley FAQ's (http://www.susanminor.org/forums/showthread.php?481-Bradley-Smoker-FAQ-s&p=748#post748)
I have the same problem.Pucks advance but burner just gets warm to the touch.My fuse was blown but still does'nt get hot after changing.Can you buy just the SG element?
Quote from: tim1 on March 20, 2011, 03:44:45 PM
Can you buy just the SG element?
Yes. Here's the Bradley Smoker replacement parts list (http://www.yardandpool.com/Bradley-Smoker-Replacement-Parts-s/341.htm?searching=Y&sort=1&cat=341&show=300&page=1) that you can buy from Yard & Pool. The burner is $54.99.
Quote from: tim1 on March 20, 2011, 03:44:45 PM
I have the same problem.Pucks advance but burner just gets warm to the touch.My fuse was blown but still does'nt get hot after changing.Can you buy just the SG element?
Call Bradley if you are still under warranty.