This is the second time I have used my smoker and I would like to smoke two racks of pork spare ribs. I will be using apple wood. My question is: what should the IT be on ribs and how long and what temp. to smoke/heat? I tried smoking a pork butt last week and got mediocre results. Any advice would be greatly appreciated. Thanks
Im
i would season the ribs with your favoite rub if you dont have one try the following listed below then cold smoke for 2 to 3 hours ( cold smoke is smoking only .. no heat ) then turn off the smoke generator and turn on the heat for the box at 200 to 220.. let cook till an IT od 175 to 185 if you want it to fall off the bone..
also spray with either orange soda or apple juice
the rub
2 table spoons sea salt
2 - 3 table spoons black pepper
2 table spoons paprika
1 table spoon cumin
1/2 table spoon garlic powder ( or you could cover ribs in minced garlic which tastes a lot better )
1 table spoon sugar
1/2 table spoon cinnimon ( if you have it available )
1 table spoon thyme
mix throughly and apply
if you like it a bit spicer .. ass more pepper and some cayenne pepper
enjoy
beefmann
If you don't have a good instant read thermometer it's hard to get an accurate IT on ribs. I generally smoke/cook until the meat pulls away and exposes about 3/4 to 1 inch of bone.
I don't take the temp on ribs either.
This is how I do spare ribs - http://forum.bradleysmoker.com/index.php?topic=7500.0
I tried the recipie and the ribs turned out great! Thanks for the help.
sneaky - so you don't actually cook the ribs in the bradley, just use it for a little smoke flavour.
makes sense.
Or Am I reading the recipe wrong ?
Curious,
You can do either, use the Bradley start to finish or move the meat to another heat source. Most of the time I move mine to either a house oven or a grill depending on what needs to be done. Ribs usually get both as I will move from the Bradley to the oven after 3 to 4 hours of smoke, then from the oven to the grill to glaze them over if I am doing a BBQ sauce finish.
Quote from: Curious Aardvark on October 28, 2008, 08:37:46 AM
sneaky - so you don't actually cook the ribs in the bradley, just use it for a little smoke flavour.
makes sense.
Or Am I reading the recipe wrong ?
You read it right. That recipe is an adaptation of an (Alton Brown) oven recipie. Since braising requires a cover, and my braising vessel wilnot fit in the bradley, I use the oven.
congrats Im..
and Currious,
I smoke and cook my ribs in the Smoker till the meas starts to pull away from the bone and there done
Beef
How long does that usually take?
I have only done them twice and that was a year ago.
First attempt was a failure. I applied too much of a rub that way too hot for my tastes. The second attempt was great but, I forgot how I did it. I just bought a spiral bound pad so I can write down what I do so I don't repat my failures.
Nathan
sherlock,
I do a typical light covering with a rub, then a smoke only for 1 hr 20 min with your favorite bisquetts then cook at a box temp of 205 to 210 for 6 to 8 hours depending on volume of ribs.. more you have longer it takes. If you have a full smoke of ribs then rotate ribs from top to bottom and front to back,
when the meat starts to pull away from the bone your getting close...i would look close at each of the bone and sure that the meat is pulling away.. then your done once it happins
Quote from: beefmann on November 06, 2008, 06:44:46 AM
sherlock,
I do a typical light covering with a rub, then a smoke only for 1 hr 20 min with your favorite bisquetts then cook at a box temp of 205 to 210 for 6 to 8 hours depending on volume of ribs.. more you have longer it takes. If you have a full smoke of ribs then rotate ribs from top to bottom and front to back,
when the meat starts to pull away from the bone your getting close...i would look close at each of the bone and sure that the meat is pulling away.. then your done once it happins
Hello Beefman ...
Being a Newbie, ... So you "Cold Smoke" for the 1.5 hrs, then close off the box, and turn on the heat for the remaining 6-8 hrs. Do you want to add any disks during this process too?? (Heat Smoke)
Do you at any point open and "Spritz" the ribs with apple juice, or anything else for extra moisture? Now the Vent on the top of the smoker? Keep that closed off as much as possible I take it, when cooking? Correct?
Thanks for your help ...
Welcome to the forum Stitches,
yes i generally cold smoke for 1 hr 20 minutes to 2 hours then cook untill the meat is done.. with ribs it works out to be:
1 hr 20 min smoke and 6 to 8 hours of cook total time 7 hr 20 min to almost 9 and half hours, sometimes a bit longer depending on the ribs. On the smoke I have the top vent 1/2 open then close to cook and generally dont add any more smoke. as for additional moisture and taste I put a small bread tray 1/2 full of orange soda. the orange soda is sunkist orange.. though you could use your favorite soda for additional taste and moisture
W E L C O M E to the Forum Stitches040!
Quote from: Stitches040 on November 10, 2008, 05:03:34 PM
Now the Vent on the top of the smoker? Keep that closed off as much as possible I take it, when cooking? Correct?
You'll want to keep the vent at least half open. You do not want excess moisture to condense on the inside of the smoker. If it drips on the food... YUCK!
Quote from: beefmann on November 10, 2008, 05:31:14 PM
1 hr 20 min smoke and 6 to 8 hours of cook total time 7 hr 20 min to almost 9 and half hours, sometimes a bit longer depending on the ribs. On the smoke I have the top vent 1/2 open then close to cook and generally dont add any more smoke. as for additional moisture and taste I put a small bread tray 1/2 full of orange soda. the orange soda is sunkist orange.. though you could use your favorite soda for additional taste and moisture
Ok ... I'm giving your recipe a try right now (Today) ... I have added some apple juice to the burnt bisquette bowl. I am also spritsing the ribs with Apple juice every 1.5-2 hrs. They Smell great.
Quote from: FLBentRider on November 10, 2008, 07:36:16 PMYou'll want to keep the vent at least half open. You do not want excess moisture to condense on the inside of the smoker. If it drips on the food... YUCK!
Ok ... You and Beef, I willl leave the vent open just a little.
Thank you all for your help. ... :thumbs:
Beefman,
Just curious as to doing a cold smoke for 2-3 hours. Doesn't this increase the risk of nasties? Assuming that a coldsmoke will be done for 3 hours at somewhere around a 90*F temp and then add into the time of getting the meat out of the danger range when smoking at 200-220, that seems to be a long time for the meat to be in the "danger zone." Just curious if that amount of time increases the risks of the nasties, especially with pork.
Thanks!
SD
SD, the smoking process is a form of curing and doesent create any nasties .. and if it does i take the meat high enough to kill any nasites to add some piece of mind...
there are a lot of compainies out there that only cold smoke anyware from 50 to 90 f for up to 24 hours or longer...
so as long as the meat is handled with care and corect procedures are taken there should be no problems