When it rains it pours....

Started by Dean405, August 13, 2011, 06:24:03 PM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Dean405

Factory warranted the plastic part at the bottom of the door. When I took the old piece off, it was busted up all over under the cover. It takes a while to change out the plastic piece only because you have to remove the stainless inner skin.

Went to re-assemble, and one of the bolts that holds the top hinge was stripped out when I went to re-install the screws (I did not cross thread it either). There was also a few of the screws that hold the stainless liner that were stripped out, but probably not a big deal on the liner, but I do have a concern that the top hinge is going to work with only one screw that will hold.

I guess the only cure is to replace the entire cabinet outside skin or tap the hole for a bigger screw. Dont think a helicoil kit would work on such thin metal.

classicrockgriller

I've placed a toothpick in the screw hole at the same time I put the screw in.

Always works for me.

mikecorn.1

Quote from: classicrockgriller on August 13, 2011, 06:28:41 PM
I've placed a toothpick in the screw hole at the same time I put the screw in.

Always works for me.

Nice. I also use the ole toothpick in the hole fix.  ;D
Mike

SamuelG

I'm waiting for my replacement to come in, I'll use the toothpick. :)


SamuelG

Sent from my iPhone using Tapatalk
SamuelG

KyNola

Steel wool works like a charm too.

muebe

Natural Gas 4 burner stainless RED with auto-clean
2 TBEs(1 natural gas & 1 LP gas)
OBS(Auberins dual probe PID, 900w finned element & convection fan mods)
2011 Memphis Select Pellet Smoker
BBQ Grillware vertical smoker(oven thermostat installed & converted to natural gas)