Modding my OBS

[Karaokegod01]

I was thinking about modding my obs with a second heating element but do not know where to start. What do I need to buy? Directions for installation? Does this void Warranty? If anyone could help me out that would be great  Thanks!

[Habanero Smoker]

I don't know if it will void your warranty, but most manufacturers will void the warranty once you make a modification. I would suspect it would void it.

Depending on your model here are the links for the mods:

Additional Element for the DBS

Additional Element for the OBS w/ Optional On/Off Switch

[Karaokegod01]

Wow seems like a pain to do all this I think since I know nothing about electricity I will just stick with 1 element or just use a pid and daisy chain from 1 element to the other

[mikecorn.1]

Wow seems like a pain to do all this I think since I know nothing about electricity I will just stick with 1 element or just use a pid and daisy chain from 1 element to the other

Depending on what you are doing, the single factory is fine. I've had mine for two years and I notice when I load Bradley down with slot of stuff, it's hard to get the temp up and forget about opening it to rotate racks. You can combat the heat loss a bit with some tricks. I am planning on doing mine soon. I got the extra element on hand to dual it out.


Sent from my iPhone using Tapatalk

[Habanero Smoker]

Wow seems like a pain to do all this I think since I know nothing about electricity I will just stick with 1 element or just use a pid and daisy chain from 1 element to the other

It's not that difficult, but you will need a PID with either option you choose. If you are going to daisy chain, and you have the OBS you should by pass the temperature controller, as an added precaution.