PID Sound-Off

[Majes]

What thermocouple is everyone using?   Are you dangling through the vent or fixed mount in the back?   If fixed mount, what rack position?

[Kahunas]

I have mine mounted to the back about mid cabinet.

[MidKnightRider]

I dangling through the vent

[muebe]

Get the dangler. You can position it just under the lowest rack ;)

[mikecorn.1]

Free hanging probe over here.


Sent from my iPhone using Tapatalk

[SouthernSmoked]

I run mine through the door but I clipped it onto a rack. This is only used for this purpose.

[TedEbear]

I have the Auber K-type TC with alligator clip.  I run it through the vent and clip it to the lowest rack that I have something smoking on.

[Majes]

I haven't had this much fun since the electronic science kits in 5th grade!    Wait............that V-8 engine model in 7th grade was pretty exiting too.

[GusRobin]

I originally used the wall mount but it wasn't long before I plugged the hole and bought a dangler probe. The issues I had were 2. (1) you should place it under your lowest rack of meat, with the fixed mount I couldn't do this. (2) The fixed probe sometimes got in the way when I had all the racks full. That is the same reason I removed the temp probe that came with the Bradley.

[ghost9mm]

Get the dangler. You can position it just under the lowest rack ;)

X 2

[beefmann]

back of the cabinet

[pensrock]

I use a type J T/C and drilled a hole through the back of the tower so the T/C rests just below the second rack from the bottom. Works great.  :)

[Kahunas]

I use a type J T/C and drilled a hole through the back of the tower so the T/C rests just below the second rack from the bottom. Works great.  :)

Yea, mine is the same place. I used a T type, I already had the wire.

[allan_37]

New to smoking so curious as to what the probe is attached to outside the smoker

[mikecorn.1]

New to smoking so curious as to what the probe is attached to outside the smoker

To the PID unit.



Sent from my iPhone using Tapatalk