Pucks sliding just short of full burner

Started by SmokinSignals, February 05, 2013, 02:01:48 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

SmokinSignals

February 05, 2013, 02:01:48 PM
My smoke generator will push the pucks just short of being on the burner all the way.  They are tilted just slighty because the track is offset from the burner.  I believe this is causing my pucks to not burn completely.  Is this normal?

iceman

#1
February 05, 2013, 03:08:17 PM
I looked at all my generators and the burner is flush and level with the track. If part of the puck is not in contact with the burner plate that would seem to be the problem. Is there any way you might be able to tweak it a bit so they line up?

Gafala

#2
February 05, 2013, 03:42:42 PM
My two cents worth sounds like the puck push rod is bent that is why they don't advance all the way or the track is dirty.
Bradley 4 rack Digital, 900 watt, Auber PID
Bradley cold smoke adapter
Char-Griller Smoking Pro BBQ Smoker with rotisserie
Brinkman Bullet Smoker
Weber 24"
Custom Hard Cure Cabinet for Salami
One Auber Master Temp monitor and two remotes with probes, up to ten remotes can be used.

Racer17

#3
February 05, 2013, 04:02:35 PM
I have an OBS and have the same problem. My slide is even with the burner, but it doesnt happen all the time. I have used it a couple of times and was hoping it would work the bugs out itself. I'm sure somebody here will know what to do
Print
Go Up Pages1
User actions