« previous next »
Pages: [1]   Go Down

Author Topic: Bisquette advance button  (Read 2746 times)

Offline afreitag

  • Newbie
  • *
  • Posts: 8
Bisquette advance button
« on: March 14, 2013, 06:52:06 pm »
The advance button has been sticking on my OBS. I took the button out and cleaned it and it pushed in and popped back out just fine. I put it back in the generator and its sticking again. Took it out again and it works fine. It only sticks when its in the generator. How can I fix this??
Logged

Offline TedEbear

  • Member Extraordinaire
  • ******
  • Posts: 2,660
Re: Bisquette advance button
« Reply #1 on: March 14, 2013, 07:12:59 pm »
Click on this for a solution:  How do I stop my puck advance button from getting stuck?

And here's a link to a whole lot of threads on it:  Sticking Puck Advance Button

« Last Edit: March 14, 2013, 07:16:25 pm by TedEbear »
Logged

Offline drano

  • Full Member
  • ***
  • Posts: 429
Re: Bisquette advance button
« Reply #2 on: March 14, 2013, 08:07:12 pm »
Yep, hole in tin is most likely a touch too small, and pinching the button.
Remove button, and give the hole a couple strokes with a fine--WARNING, it doesn't take much. 
Repeat if necessary.
Logged

Offline mflattop

  • Newbie
  • *
  • Posts: 1
Re: Bisquette advance button
« Reply #3 on: March 23, 2013, 10:48:54 am »
It did the same thing for me. I pushed in about halfway and it worked fine.
Logged
Pages: [1]   Go Up
« previous next »