How to run a auber plug and play with a bds

[oldsmoker]

Would like to know how to set it up and on smoke gen do i use both sides? Hooked up the way book said set temp to 120 and it went to 127 and keept going. Do have a double element.did a manual run and still keeps going past 120.  I mean i did a man tune of the pid and it still wants to keep rising in temp.

[Indy Smoker]

I have an auber on my bad also.
For the beds the smoke generator is not controlled by the auber and has to be manually set. The auber should control the tower only.
You mentioned you did an autotune-did you let this cycle complete? Do you have your probes properly set inside the cabinet? During the autotune proves the temp will continue to climb as the device 'learns' how to properly cycle the element(s). This process can take quite a while if I remember.


Sent from my iPhone using Tapatalk - now Free

[Indy Smoker]

I meant BDS - darn spellcheck :)


Sent from my iPhone using Tapatalk - now Free

[oldsmoker]

So how do you hook it up please what cables go where?

[devo]

Go here and read the page, if you still have questions than by all means come back and we will see if we can help

http://www.susanminor.org/forums/showthread.php?672-Auber-Plug-amp-Play-PIDs-Single-Dual-Probes

You might also want to go over this page to get yourself used to the different settings
http://forum.bradleysmoker.com/index.php?topic=18346.0

[oldsmoker]

Thanks for the help. on tuning it i had to change the p value from 70 to 140 with double elements all working great again thanks for the help.