Author Topic: sausage stuffers  (Read 5174 times)

Offline kmarr

  • Newbie
  • *
  • Posts: 13
sausage stuffers
« on: November 14, 2015, 09:48:50 am »
Are all the stuffer tubes 7 1/2 " long or do they make longer ones so you can put the whole strand on at once.
Thanks Kelly

Offline AkBillyBow

  • Newbie
  • *
  • Posts: 36
Re: sausage stuffers
« Reply #1 on: November 22, 2015, 09:35:21 pm »
I haven't seen any that are longer.  It would make sense though!

AkBillyBow

Offline Habanero Smoker

  • Member Extraordinaire
  • ******
  • Posts: 15,315
  • KCBS - Master Certified Barbecue Judge
Re: sausage stuffers
« Reply #2 on: November 23, 2015, 01:45:35 am »
There use to be a member who custom made them. If you check on eBay you will find them, you just need to make sure they are the right size to fit the locking ring that attaches the tubes to the cylinder.


     I
         don't
                   inhale.
  ::)

Offline byacey

  • Newbie
  • *
  • Posts: 6
Re: sausage stuffers
« Reply #3 on: November 29, 2020, 07:18:11 pm »
I found that by putting too much casing on the tube, it tends to dry up and doesn't slide off the tube as smoothly after you use up about half the casing.
Edit: This is with a crank operated cylindrical stuffer.
I saw a hydraulic driven stuffer in a meat processing shop that would fill a 20 foot casing in less than 15 seconds, very fast. In that situation, the casing doesn't have time to dry out and it slid off the tube very easily.

 They had a long stainless table, and one guy would run with the tied off end of the casing to the far end of the table as it was being filled; another guy was operating the stuffer and guiding the casing off the end of the tube.









































































































































































































































































































































































































































































« Last Edit: December 01, 2020, 09:11:05 am by byacey »