Maple cured Bacon by Ten Point 5

Started by Shasta bob, December 18, 2020, 01:24:34 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Shasta bob

Anybody have the recipe for the Maple cured bacon by Ten Point 5? my recipe site is gone.  :(
2 ea. Bradley - OBS
Auber PID
Bradley cold smoke adapter
Temp Test Intelligent Thermometer
Weber Gensis BBQ
Weber Baby Q
Smoke from thermoworks
Blackstone 4 burner

oldsmoker

Had in my smoking book. 2oz kosher salt about1/4 cup.  2tsp cure #1   1/4 cup maple sugar or packed brown  sugar  1/4 cup maple syrup.
OLDSMOKER

cathouse willy

Here's what I have. It's my go to bacon recipe.



    Maple Cured Bacon
    From Tenpoint5
     

     

    Ingredients:

      2 oz. Kosher salt (about 1/4 cup)
      2 tsp. Cure #1 (aka pink salt, InstaCure #1, Prague Powder #1)
      1/4 C. Maple sugar or packed brown sugar
      1/4 C. Maple syrup


      5 lb. fresh pork belly
      (Makes enough for a 5 lb. belly)

    Directions:

      Combine all dry ingredients in a bowl and mix well. Add syrup and stir
      until well combined.
        If the mixture is too thick, you can add more syrup to thin it.



      Rub cure mixture on belly making sure to cover the entire surface. Place
      skin side down in a 2 gallon sealable bag, and expel all air, and fold the
      empty end of the bag under so that the belly is in close contact with the
      bag. During the curing time the belly will release liquid, and it is
      important that this liquid stays in contact with the meat.
     
       


      Refrigerate at 34 – 40°F (the closer to 40°F the better) for 5 to 7 days,
      until belly is firm to the touch with no soft spots. During the curing
      time, turn the bag over once a day or once every other day to redistribute
      the cure.



      When belly is fully cured, rinse it THOROUGHLY, and pat it dry. Place it
      on an inverted Bradley rack set over a baking sheet, and air dry uncovered
      in the refrigerator overnight (12 – 24 hours).
        If you don't have the refrigerator space to air dry the bacon you can do
        this step in the Bradley. Preheat the Bradley to 100 – 120°F with vent
        wide open, and place your room temperature bacon in the smoker. To get
        these low temperatures you will need to use the "cold smoke setup". Do
        not apply smoke at this time. You just want to dry the bellies until
        they are tacky when touched. Depending on the size of your load, this
        generally takes about 2 hours, but to be on the safe side check the
        bellies after one hour.
       

    Smoking/Cooking

      Once bacon has been "air dried" place into a 120 - 140° preheated smoker
      with vent half open.
        If air dried in the refrigerator, set the bellies out in room
        temperature for 1 - 2 hours before placing them in the smoker.

        If you air dried it in the Bradley, increase the temperature to 120 -
        140°, close to vent to half open, and begin to apply your smoke.

        The amount of smoke is up to you. I generally will only apply 2 hours,
        using maple.



      After you have applied your smoke, increase the heat to 160°F, and
      smoke/cook the bacon until an internal temperature of 150°F is reached.
        Or increase the temperature to 150°F, and smoke/cook until an IT of
        140°F is reached.


      After the desired internal temperature has been reached, remove from
      smoker and allow to cool slightly. When cool enough to handle, but still
      warm pull the skin off (you may need a sharp knife to help) making sure
      you leave as much fat on the bacon as possible.

rnmac

This is his posting minus the pics. Hope it helps.

Maple Cured Bacon
From Tenpoint5

 

Ingredients:
2 oz. Kosher salt (about 1/4 cup)
2 tsp. Cure #1 (aka pink salt, InstaCure #1, Prague Powder #1)
1/4 C. Maple sugar or packed brown sugar
1/4 C. Maple syrup
5 lb. fresh pork belly
(Makes enough for a 5 lb. belly)

Directions:
1.   Combine all dry ingredients in a bowl and mix well. Add syrup and stir until well combined.
   If the mixture is too thick, you can add more syrup to thin it.

2.   Rub cure mixture on belly making sure to cover the entire surface. Place skin side down in a 2 gallon sealable bag, and expel all air, and fold the empty end of the bag under so that the belly is in close contact with the bag. During the curing time the belly will release liquid, and it is important that this liquid stay in contact with the meat.
   Note - The skin was already removed at the Locker Plant on this one.
   IMPORTANT: When using plastic sealable bags, place the bags on a rimmed cookie sheet or in a pan. This will catch any leakage from the bags, will keep your refrigerator clean, and you can also recover any lost liquid, and return it to the bag.
 
3.   Refrigerate at 34 – 40°F (the closer to 40°F the better) for 5 – 7 days, until belly is firm to the touch with no soft spots. During the curing time, turn the bag over once a day or once every other day to redistribute the cure.

4.   When belly is fully cured, rinse it thoroughly, and pat it dry. Place it on an inverted Bradley rack set over a baking sheet, and air dry uncovered in the refrigerator overnight (12 – 24 hours).
   If you don't have the refrigerator space to air dry the bacon you can do this step in the Bradley. Preheat the Bradley to 100 – 120°F with vent wide open, and place your room temperature bacon in the smoker. To get these low temperatures you will need to use the "cold smoke setup". Do not apply smoke at this time. You just want to dry the bellies until they are tacky when touched. Depending on the size of your load, this generally takes about 2 hours, but to be on the safe side check the bellies after one hour.
   

Smoking/Cooking
5.   Once bacon has been "air dried" place into a 120 - 140° preheated smoker with vent half open.
   If air dried in the refrigerator, set the bellies out in room temperature for 1 - 2 hours before placing them in the smoker.
   If you air dried it in the Bradley, increase the temperature to 120 - 140°, close to vent to half open, and begin to apply your smoke.
   The amount of smoke is up to you. I generally will only apply 2 hours, using maple.

6.   After you have applied your smoke, increase the heat to 160°F, and smoke/cook the bacon until an internal temperature of 150°F is reached.
   Or increase the temperature to 150°F, and smoke/cook until an IT of 140°F is reached.

7.   After the desired internal temperature has been reached, remove from smoker and allow to cool slightly. When cool enough to handle, but still warm pull the skin off (you may need a sharp knife to help) making sure you leave as much fat on the bacon as possible.

Shasta bob

2 ea. Bradley - OBS
Auber PID
Bradley cold smoke adapter
Temp Test Intelligent Thermometer
Weber Gensis BBQ
Weber Baby Q
Smoke from thermoworks
Blackstone 4 burner