pid dual probes manual

Toker · January 15, 2010, 09:43:14 PM

Hi everyone, did the manual for the new pid dual probes WSD-1200CPH been post online somewhere? I did not received my pid yet and i have a couple of questions so instead of asking if the manual could be found online i would like someone giving me the link pls. THX

classicrockgriller · January 15, 2010, 09:45:33 PM

I got it and if you pm your e-mail I'll send it

classicrockgriller · January 15, 2010, 09:59:00 PM

sent it.

Let me know if you got it.

Toker · January 15, 2010, 10:06:52 PM

THX A MILLION CRG! it answered all my questions. :D :D

classicrockgriller · January 15, 2010, 10:12:25 PM

Well it looked like spanish to me. :D

Hoss · January 15, 2010, 10:23:07 PM

Quote from: classicrockgriller on January 15, 2010, 10:12:25 PM
Well it looked like spanish to me. :D

You gotta flip it over! Its enlish on the other side :P

Quarlow · January 15, 2010, 10:29:11 PM

Me thinks the monkey is cross eyed. ;D

classicrockgriller · January 15, 2010, 10:32:06 PM

Well at least I'm not standin by some trees and have a nazi flag wav'in

Toker · January 15, 2010, 10:57:03 PM

Anyway you mostly dont need to play with the settings exepted for the temp and foof internal. The rest is supposed to be already adjusted for the bradley smoker. Maybe for auto-tune once a while but not neccerarly.

classicrockgriller · January 15, 2010, 10:59:59 PM

What if you have dual heaters?

Toker · January 15, 2010, 11:01:48 PM

What is dual heater? A 2nd elements?

classicrockgriller · January 15, 2010, 11:04:01 PM

yep, do the values change?

classicrockgriller · January 15, 2010, 11:05:07 PM

Just did it today so that Gabi and the new Auber can start off right!

Quarlow · January 15, 2010, 11:09:45 PM

that should help ya down there in the cold zone. ;D

Toker · January 15, 2010, 11:10:16 PM

yes just do an auto tune do this
Press and hold SET key for 4 seconds until LED display "LCK" on the left window, then release the SET key. The display on the right window will show "0". To get into parameters setting mode, you need to key in the pass code. Use "+" and "-"keys to adjust the display to 166 (which is the pass code) and press SET
You need to change the 0 for 1 Auto-tune function. Set AT to 1 then exit the menu. The display will start to flash alternately between AT and the current temperature, which indicates auto-tuning is in progress. When the display stops flashing, the auto-tuning is finished

Don't worry it's gonna take up to 30 minutes to process.